Zoetrope instructions -

Photos to help make our kits.











     Glue the black card to the picture               Cut out the two pieces and glue the end to make a long strip

Also cut out the small strips in between each picture and snip out the pieces below each picture.











                        Fix by glueing  he circular wooden cog onto the wooden rod about 2 cm from the end. Leave to dry.

                             Pass the straw over the stick and then glue another wooden cog to the bottom end of the stick.













                                     Like this                                                              

                                                                                                    

YOU CAN DO THE NEXT IN TWO WAYS;

EITHER GLUE THE OTHER END OF THE STRIP SO THAT IT FORMS A CIRCLE – the pictures inside and the small tabs will be seen at the bottom. These should be glued and the correx disc pushed down through the drum onto it. Wait till it dries.

OR

Place this picture on a flat surface (pictures upward) with the small slits at the bottom of the picture. They are numbered. Place the disc with the hole in it on its side and roll the pictures around the edge. As you do so, Sellotape / glue the two things together. The small cut out bits at the bottom can be glued to the under side of the black disc too.








                                         







Hold the straw & spin the stick using the wooden wheel.

Look into the slits and you will see the moving objects.

Have fun!                                                                                 The zoetrope will spin round –



Glue the wooden cog to the bottom of the black disc.


Then glue the last cog on the top of the black disc

to secure

                                                                                                                                                                                                                                    then look into the slits of the unit to see a moving object

T.

Please wait for glue to set