Zoetrope instructions -
Photos to help make our kits.
Glue the black card to the picture Cut out the two pieces and
glue the end to make a long strip
Also cut out the small strips in between each picture and snip out the pieces below
each picture.
Fix by glueing the circular wooden cog onto the wooden rod
about 2 cm from the end. Leave to dry.
Pass the straw over the stick and then glue another
wooden cog to the bottom end of the stick.
Like this
YOU CAN DO THE NEXT IN TWO WAYS;
EITHER GLUE THE OTHER END OF THE STRIP SO THAT IT FORMS A CIRCLE – the pictures inside
and the small tabs will be seen at the bottom. These should be glued and the correx
disc pushed down through the drum onto it. Wait till it dries.
OR
Place this picture on a flat surface (pictures upward) with the small slits at the
bottom of the picture. They are numbered. Place the disc with the hole in it on its
side and roll the pictures around the edge. As you do so, Sellotape / glue the two
things together. The small cut out bits at the bottom can be glued to the under side
of the black disc too.